Tracpipe Tee

Tracpipe Equal Tee Gas Pipe Fitting

Tracpipe 15mm Tees are used to make junctions in both Tracpipe Flexible Gas Pipe Full Coils and Tracpipe Semi-rigid Gas Pipe Cut Lengths No threading, welding or hot-work is needed and no special tools are required.
Together with Tracpipe Silicone Tape they eliminate unnecessary black iron fittings – reducing potential leak points. Tracpipe provides a major benefit  over traditional rigid piping methods by significantly reducing installation & labour time

Jointing flexible gas pipe with Tracpipe Tees
Each AutoFlare fitting uses back nut and 2 split rings.
Simply slide the nut back over the cut pipe end, the two split rings will be aligned with the first corrugation of the pipe. Slide the nut forward to trap the split rings.
Align the AutoFlare fitting with the back nut and hand tighten the threads then use an appropriate spanner size to tighten the fitting until it is tight.
Torque should be applied similar to that used when as making up a flared pipe joint.
All Autoflare tees are manufactured in brass they are BS 7838 Approved, Tested by Advantica and BSI Kitemarked they conform to all Gas Industry Standards in the U.K.