Yorkshire Xpress S21s Press Fit Obtuse Street Elbow Copper

Yorkshire Xpress S21s Press Fit Obtuse Street Elbow Copper


Unlike the S21 45 degree elbow the S21s Street elbow is designed so the male side would easily fitting inside another xpress fitting while Copper tube will fit inside the female end.

Xpress Press Fit Copper fittingsare capable of operating between -24c & 110c and rated at 16 bar throughout the temperature range.

The Elbow is WRAS & DVGW approved which proves the quality of the product. Xpress copper fittings are designed for use with both hot & cold water services, Solar & in heating & chilled water services.


BSi Kitemarked
BS 8537:2010 - Copper and copper alloys. Plumbing fittings. Specification for press ends of plumbing fittings for use with metallic tubes.
Pegler Yorkshire XPress range of press fittings suitable for use with hard and half-hard copper tube.


Type 1 Fittings
Ambient Temperature Range: 15°C to 95°C. Maximum Operating Pressure (MOP): 16 bar.
Available in any combination of press-end sizes: 12mm, 15mm, 22mm, 28mm, 35mm, 42mm, 54mm, 66.7mm,76.1mm and 108mm.

25 / 30 Years Guarantee
The Xpress Copper, Gas, Stainless ranges are guaranteed for 25 years when installed along with other manufacturers’ pipeline components conforming to the specified standard.
30 Years Where pipelines are constructed exclusively from compatible XPress Copper, Gas, Stainless and Solar fittings and tubes, the resulting installations will be deemed XPress Systems and qualify for a 30 year guarantee.

Benefits
•   A totally heat-free jointing solution
•   Reduced installation times provides major installed cost savings
•   No need for hot works permits or additional costly insurance
•   Sizes from 15mm up to 108mm
•   Systems have an exceptionally clean bore with no flux residues
•   Cover a wide variety of applications in modern building services
•   System guarantees of 30 Year for XPress Copper/Stainless and 10 Years for XPress Carbon
•   Excellent system performance from -24 to 110°C at a maximum working pressure of 16 bar and -20 to 70°C at 5 bar (1 bar within buildings) for Gas fittings
•   Designed for hydrau licsystem testing at up to 1.5 times working pressure, to a maximum of 16 bar*


*For testing at higher pressures and compressed air pipeline systems advice should be sought from Pegler Yorkshire