Yorkshire Xpress S12 Press Fit Elbow Copper

Yorkshire Xpress S12 Press Fit Elbow Copper


Used by Biomass Installers the Press fit S12 90 elbow is available from 15mm up to 108mm & is stocked at Collister & Glover.

The Xpress range of fittings are designed to reduce installation time & cost by using a Pressfit tool. By using the Xpress range you no longer need to purchase gases, adhesives, fluxes, or solders.

The fitting is made from Copper or Copper alloy (Typically Gunmetal) contains black Ethylene Propylene Diene Monomer (EPDM) O rings & comes wirth a Guaranteed for 25 years against all manufacturing defects.


BSi Kitemarked
BS 8537:2010 - Copper and copper alloys. Plumbing fittings. Specification for press ends of plumbing fittings for use with metallic tubes.
Pegler Yorkshire XPress range of press fittings suitable for use with hard and half-hard copper tube.


Type 1 Fittings
Ambient Temperature Range: 15°C to 95°C. Maximum Operating Pressure (MOP): 16 bar.
Available in any combination of press-end sizes: 12mm, 15mm, 22mm, 28mm, 35mm, 42mm, 54mm, 66.7mm,76.1mm and 108mm.

25 / 30 Years Guarantee
The Xpress Copper, Gas, Stainless ranges are guaranteed for 25 years when installed along with other manufacturers’ pipeline components conforming to the specified standard.
30 Years Where pipelines are constructed exclusively from compatible XPress Copper, Gas, Stainless and Solar fittings and tubes, the resulting installations will be deemed XPress Systems and qualify for a 30 year guarantee.

Benefits
•   A totally heat-free jointing solution
•   Reduced installation times provides major installed cost savings
•   No need for hot works permits or additional costly insurance
•   Sizes from 15mm up to 108mm
•   Systems have an exceptionally clean bore with no flux residues
•   Cover a wide variety of applications in modern building services
•   System guarantees of 30 Year for XPress Copper/Stainless and 10 Years for XPress Carbon
•   Excellent system performance from -24 to 110°C at a maximum working pressure of 16 bar and -20 to 70°C at 5 bar (1 bar within buildings) for Gas fittings
•   Designed for hydrau licsystem testing at up to 1.5 times working pressure, to a maximum of 16 bar*


*For testing at higher pressures and compressed air pipeline systems advice should be sought from Pegler Yorkshire