Polyplumb Solid Underfloor Heating House Packs 80M

Polyplumb Solid Red Floor Panel System 6, 7, 8, 9 and 10  zone  Floor House Packs for 80 Metres or rooms approx. 30 x 28 feet

A typical underfloor heating system is generally split into zones, each zone representing one room. A zone can be a bathroom, a kitchen, a bedroom etc.
Each zone is controlled by a thermostat located within the room that increases or decreases the heat output from the heating system.
So a four zone system can have up to four rooms, for larger rooms two or more zones can be allocated.

Polyplumb under floor central heating can be permanently built into solid concrete or screeded floors. As required by current Building Regulations, insulation is built into the floor directly beneath the unique Polyplumb floor panel. The heating pipe is simply slotted in and then permanently covered by the screed. Suitable for all floor coverings.


























Key Design And Illustration Information
Maximum Heat Outputapprox. 100W/m2
Recommended Design Flow Temperature50°c
Maximum Circuit Length100m (for 15mm pipe)
120m (for 18mm pipe)
Maximum Coverage Per Circuit11.1m2 at 100mm centres
21.2m2 at 200mm centres
30m2 at 300mm centres (for 18mm pipe)

Each heating pack contains a selection of Screeded Floor Panels, Edge Insulation, Manifold, Isolation Valves, Pump Pack, Conduit Pipe Coils and Pipe stiffeners.

As a major Polypipe supplier we can advise you on design layouts and product requirements.
If you would like a quotation based on your own measurements please click the image and fill in the form.
Get a free Underfloor Heating Quotation