Pipe Clamps Galv Base Plate - 132

A structural pipe clamp base plate for all aspects of vertical post support. This fitting when used as a base plate for guardrailing should always be positioned with the holes across the line of the guardrail to give maximum strength. The holes in the base plate are large enough to enable the use of mechanical or chemical anchor fixings.

Pipe Clamp Sizing Table
 Nominal Bore of the Pipe
FittingTube Size
Outside Diameter
3242.4mm321 1/4"
4048.3mm401 1/2"

Much confusion is caused by the sizing designation of Pipeclamps.
All inch sizes referred to are Nominal Bore sizesand relate to the Nominal {not actual} bore of the pipe or tube used.
For example: The 1" PIPECLAMP willfit a 1" or 25mm Nominal Bore Pipe or tube with an OD of 1 11/32" or 33.7mm
Please refer to our Sizeguide  before ordering