Pipe Clamps Crosses

Pipe clamp crosses are typically used to create 4 way 90 degree joints. These can connect two horizontal and a single vertical pipe, with a continuous pipe usually passing through the centre of the clamp, with the others are cut and connected to the clamp.

Much confusion is caused by the sizing and designation of Pipeclamps.
All inch sizes referred to are Nominal Bore sizes and relate to the Nominal {not actual} bore of the pipe or tube used.
For example: The 1" PIPECLAMP will fit a 1" or 25mm Nominal Bore Pipe or tube with an OD of 1 11/32" or 33.7mm.
Please refer to our Sizeguide before ordering

Pipe Clamps Crosses