Philmac Large Bore Metric Fittings
Philmac Large Bore Metric Fittings caters for fitting sizes 75mm to 110mm.
Standards: Philmac Large Bore range of compression fittings hold certificates for the following standards:
BS 6920: Products for use incontact with water intended for human consumption with regards to their effect on the quality of water.
Philmac Large Bore exceeds the requirements of:
ISO 14236: Plastics pipes and fittings -- Mechanical-joint compression fittings for use with polyethylene pressure pipes in water supply systems
Suitable for: Philmac Large Bore fittings are suitable for use with pipes manufactured to the dimensions specified in the following standards:
BS6730: Specification for black polyethylene pipes up to nominal size 63mm for above ground use for cold potable water.
BS 6572: Specification for blue polyethylene pipes up to nominal size 63mm for below ground use for potable water.
BS EN 12201-2:2003: Plastic piping systems for water supply. Polyethylene (PE). Pipes.
EN 12201: Plastic piping systems for water supply. Polyethylene (PE).
ISO 4427: Plastics piping systems -- Polyethylene (PE) pipes and fittings for water supply
Thread Standards: Philmac Large Bore threads and flanges comply with the requirements of the following standards:
BS21: Specification for pipe threads for tubes and fittings where pressure-tight joints are made on the threads.
ISO7.1: Pipe threads where pressure joints are made on the threads.
AS 2129 Table E (Drill Pattern): Flanges for pipes, valves and fittings
