Tracpipe Autoflare Split Rings
We are a leading UK TracPipe supplier.
TracPipe split rings for the Autoflare ® BSP Taper Fittings
All Tracpipe fittings are supplied with split rings. These are replacements in case they get damaged or lost.
Packs either come in two pairs or five pairs depending on the size of the fitting
Jointing flexible gas pipe with Tracpipe Tees
Each AutoFlare fitting uses back nut and 2 split rings.
Simply slide the nut back over the cut pipe end, the two split rings will be aligned with the first corrugation of the pipe. Slide the nut forward to trap the split rings.
Align the AutoFlare fitting with the back nut and hand tightenthe threads then use an appropriate spanner size to tighten the fitting until it is tight.
Torque should beapplied similar to that used when as making up a flared pipe joint.
All Autoflare tees are manufactured in brass they are BS 7838 Approved, Tested by Advantica and BSI Kitemarked they conform to all Gas IndustryStandards in the U.K.